Panasonic GA-ML Series Manual page 291

Click the MAC-Based Access Control tab to display the following
window.
Figure 9-8 802.1X Ports Settings (MAC-Based Access Control)
In the section of MAC-Based Access Control, you can configure the
following parameters.
Parameter
From Port/ To Port
Number of
Supplicants
Admin Control
Direction
Quiet Period
Transmission Period
Supplicant Timeout
Choose the port you use.
Enter the maximum number of authenticated users who
are allowed on the port(s). The range is from 1 to 512.
Choose the control direction of traffics on the port(s).
The options available are as follows.
• Both - controls traffics in both directions
• In - controls traffics in Inbound direction, only.
Enter the quiet period. This is the number of seconds,
for a switch, to maintain the quiet state after failing an
authentication process. The range is from 1 to 65,535
(seconds).
Enter the transmission period. This is the number of
seconds needed, for a switch, to wait for the EAP
requests/identity-frames, which come from supplicants.
When passing the period, requests are re-transmitted.
The range is from 1 to 65,535 (seconds).
Enter the value of the supplicant timeout. This is the
number of seconds needed to wait for the response
coming from the supplicant. If this period passes, the
supplicant message becomes time-out. This is not
applied to EAP request ID. The range is from 1 to
65,535 (seconds).
9.2.4 802.1X Ports Settings
Overview
9 Security
289