Panasonic GA-ML Series Manual page 105

In the section of VLAN Interface Settings, you can configure the
following parameters.
Parameter
VLAN Mode
Acceptable Frames
Checking Ingress
VLAN Precedence
Native VLAN
VID
Action
Adding Mode
VLAN Range Allowed Enter the VLAN range allowed.
Clone
From Port/ To Port
Click Apply to reflect the change.
Click Back to return to the previous window.
Choose Trunk on the VLAN Mode to display the following window.
Figure 5-23 VLAN Interface (Edit and Trunk)
Choose the option of VLAN mode. The options available
are Access, Hybrid, Trunk, Promiscuous and Host.
Choose an operating option for acceptable frames.The
options available are Tagged only, Untagged only
and Admit All.
This parameter enables or disables a function of
checking Ingress.
Choose an option for VLAN Precedence. The options
available are MAC based VLAN and Subnet based
VLAN.
If you set this option to on, the native VLAN function
becomes enabled.
This parameter becomes available if Native VLAN
option is set to on. Enter the VLAN ID you use. The
range is from 1 to 4,094.
Choose the action you perform (or execute). The
options available are Nothing, Add, Delete, Tag and
Untag.
Choose to add one of these parameters: untagged and
tagged.
If you choose this option, you need to enable the clone
function.
Choose the port you use.
5 L2 Features
5.2.6 VLAN Interface
Overview
103