Panasonic GA-ML Series Manual page 138

5.7 L2 Multicast Control 5.7.1 IGMP Snooping 5.7.1.1 IGMP Snooping Settings
Figure 5-46 IGMP Snooping Settings (Edit and Revise)
In the section of IGMP Snooping VLAN Settings, you can configure the
following parameters.
Parameter
Fast Leave
Querier State
Query Version
Query Interval
Maximum Response
Time
Robustness Variable
Final Member Query
Interval
Proxy Reporting
Source Address
Rate Limiting
(or Band Limiting)
Click Apply to reflect the change.
This parameter enables or disables a function of an
IGMP Snooping fast leave. If it is enabled and the IGMP
leave messages are received, that makes members leave
immediately.
This parameter enables or disables the querier state.
Choose the general query-packet version transmitted by
an IGMP Snooping querier. The values to choose are 1,
2 and 3.
Enter the interval for an IGMP Snooping querier
periodically to transmit general query messages of
IGMP. The range is from 1 to 31,744.
Enter the maximum response time (in second), which is
advertised by an IGMP Snooping query. The range is
from 1 to 25.
Enter the robustness variable to use it for IGMP
Snooping. The range is from 1 to 7.
Enter the transmission interval of (channel) query
messages of IGMP group unique or group source
unique. The range is from 1 to 25.
This parameter enables or disables a function of proxy
reporting.
Enter a source IP address of the proxy reporting. This
option becomes enabled if you choose Enabled from
Proxy Reporting.
Enter the value of a band limiting. The range is from 1
to 1,000. If you set No Limitation to on, a band
limiting is not applied for this profile.
5 L2 Features
Overview
136