Panasonic GA-ML Series Manual page 217

Parameter
Confirm Action
Exceed Action
Choose a confirm action. The action specifies the action
to execute for green colored packets. If the action is not
specified, the default action is to Transmit. The options
available are as follows.
• Drop - This option allows you to drop the packets.
• Set-DSCP-Transmit - This option allows you to
configure and transmit the value of new DSCP to
packets. Enter the DSCP value in the entry field
displayed.
• Set-1P-Transmit - This option allows you to
configure and transmit the value of new IEEE 802.1p
to packets. Enter the IEEE 802.1p value in the entry
field displayed.
• Transmission - If you choose this option, packets
are transmitted without switching them.
• DSCP-1P Configuration - This option allows you to
configure and transmit the value of new DSCP and
IEEE 802.1p to packets. Enter the values in the entry
field displayed.
Choose the exceed action. The action specifies the
action needed on the packets, which exceed the
bandwidth-limitation. Regarding a two-rate policer, if
the exceed action is not specified, the default action is
Drop. The options available are as follows.
• Drop - This option allows you to drop packets.
• Set-DSCP-Transmit - This option allows you to
configure and transmit the value of new DSCP to
packets. Enter the value in the entry field displayed.
• Set-1P-Transmit - This option allows you to
configure and transmit the value of IEEE 802.1p to
packets. Enter the value in the entry field displayed.
• Transmission - This option allows you to transmit
packets without switching them.
• DSCP-1P Configuration - This option allows you to
configure and transmit the value of new DSCP and
IEEE 802.1p to packets. Enter the values in the entry
field displayed.
7 QoS (Quality of Service)
7.2.7 Aggregate Policer
Overview
215