Panasonic GA-ML Series Manual page 250

Figure 8-15 ACL Access List (Add Rules, a standard IP ACL)
In the section of Adding ACL Rules, you can configure the following
parameters.
Parameter
Sequence Number
Action
Source
Destination
Time Range
Enter the ACL rule number. The range is from 1 to
65,535. If you do not specify the number, it is
automatically generated.
Choose an action to execute with this rule. The options
available are Permit and Deny.
Choose and enter the source information. The options
available are as follows.
• Optional - Evaluates the optional source traffic
according to this rule condition.
• Host - Uses and enters a source host IP address.
• IP - Uses and enters a group of source IP addresses
by using a Wildcard bitmap. The bit corresponding
to the bit value of 1 is ignored, but the bit
corresponding to the bit value of 0 is checked.
Choose and enter the destination information. The
options available are as follows.
• Optional - Evaluates the optional destination traffic
according to this rule condition.
• Host - Uses and enters an IP address of the
destination host.
• IP - Uses and enters a group of a destination IP
addresses by using a Wildcard bitmap. The bit
corresponding to the bit value of 1 is ignored.The bit
corresponding to the bit value of 0 is checked.
Enter the name of the time-range profile to be used in
this ACL rule. The number of characters for the name
can be up to 32.
8 ACL (Access Control List)
8.2.1 Standard IP ACL
Overview
248