Stp Port Settings - Panasonic GA-ML Series Manual

5.3.2

STP Port Settings

Use the following window to implement the settings on STP ports and
display its settings.
Choose L2 Features > STP > STP Port Settings to display the following
window.
In the section of STP Port Settings, you can configure the following
parameters.
Parameter
From Port/ To Port
Ports to apply
Cost
State
Guard Route
Figure 5-34 STP Port Settings
Choose the port you use.
Enter the cost value. The range is from 1 to
200,000,000. the value defines the metric, which
indicates a relative cost of a forwarding packets to the
port list specified. The port cost can be set as the metric
value or automatically. The default value is [0]
(automatic). If you set 0 to the external cost, the speed
of forwarding packets to the specified port is
automatically set on a list of the optimal efficiency. The
default port of 100Mbps port costs 200,000, and it
costs 20,000 for a Gigabit port. The lower the numerical
value, the higher possibility of transferring packets
(from the port) will be.
This parameter enables or disables an STP port state.
This parameter enables or disables a guard route
function.
5 L2 Features
5.3.2 STP Port Settings
Overview
120