Panasonic GA-ML Series Manual page 339

Parameter
IP
Click Apply to reflect the change.
In the section of ARP Inspection VLAN Logging, you can configure the
following parameters.
Parameter
VID List
State
Click Apply to add a new entry.
Click Edit to edit the configuration of the entry specified.
If two or more pages exist, enter the page numbers. Then click Go to move
to a specific page.
In the section of ARP Inspection Filtering, you can configure the
following parameters.
Parameter
ARP Access List Name Enter the name of the ARP access list to use. The
VID List
Static ACL
This parameter enables or disables the IP option. The
parameter checks a disabled IP address and an
unexpected IP address on the ARP body. In addition, the
parameter checks the validity of an IP address of the
ARP payload. The sender IP in both the ARP request and
response and the target IP of the ARP response are
verified. Packets whose destinations are these IP
addresses (e.g. 0.0.0.0 and 255.255.255.255) and all
the IP multicast addresses are dropped. The sender IP
addresses are checked by all the ARP requests and
responses. Target IP addresses are checked by ARP
responses.
Enter the VLAN ID you use. You can enter its
consecutive VLAN IDs by delimiting with a comma or
enter the range of VLAN IDs by delimiting with a
hyphen. The range is from 1 to 4,094.
This parameter enables or disables ARP inspection VLAN
logging of the VLAN specified.
number of characters for the name can be up to 32.
Enter the VLAN ID you use. You can enter its
consecutive VLAN IDs by delimiting with a comma or
enter the range of VLAN IDs by delimiting with a
hyphen. The range is from 1 to 4,094.
Click Yes or No if you need to use a static ACL.
9.7.1.2.2 ARP Inspection Settings
Overview
Overview
Overview
9 Security
337