Figure 3-19 Positioning The Leads; Figure 3-20 Securing The Leads With A Clip - Detroit Diesel DDEC VI Application And Installation

Soldering splice connectors is optional. To solder splice connectors:
1. Position the leads, so one overlaps the other. See Figure 3-19.
Figure 3-19 Positioning the Leads
2. Secure the leads with a commercially available clip and hand tool. See Figure 3-20.
Figure 3-20 Securing the Leads With a Clip
3. Use a suitable electronic soldering iron to heat the wires. Apply the solder to the heated
wire and clip (not to the soldering iron) allowing sufficient solder flow into the splice joint.
All information subject to change without notice. (Rev. 01/07)
7SA827 0701 Copyright © 2007 DETROIT DIESEL CORPORATION
DDEC VI ELECTRONIC CONTROLS APPLICATION AND INSTALLATION
3-79