Detroit Diesel DDEC VI Application And Installation page 361

5.26 TRANSMISSION INTERFACE
DDEC VI can be interfaced to manual or automatic/automated transmission over the J1939
data link.
5.26.1 MANUAL TRANSMISSIONS
The interface for manual transmissions is provided through the J1939 data link.
Programming Requirements and Flexibility
The options for manual transmissions are listed in Table 5-79.
Parameter
Group
2
10 Eng Brk Driveline Clsd Min Speed
13
13
13 Trans Neutral Input Config
Table 5-79 Manual Transmission Options
5.26.2 MERCEDES AGS2 TRANSMISSION
The AGS2 transmission is only used with the MBE900 engine and has additional wiring
requirements.
On non-multiplexed vehicles, the following outputs are required on the CPC:
□ Neutral Start Function
□ Backup Lamp Output
□ Check Trans Lamp Output
□ Trans Temp Lamp Output
All information subject to change without notice. (Rev. 01/07)
7SA827 0701 Copyright © 2007 DETROIT DIESEL CORPORATION
DDEC VI ELECTRONIC CONTROLS APPLICATION AND INSTALLATION
Parameter
Transmission Type
Clutch Switch Config
4 08 DI Selection
Setting
DIRECT ENGINE START
0 – Manual Transmission without Neutral Switch
MCM ENGINE START
3 – Manual Transmission with Neutral Switch
Series 60 – 800 rpm
MBE 4000 (with neutral sw) – 800 rpm
MBE 4000 (without neutral sw) – 1100 rpm
MBE 900 – 800 rpm
1 – 1 Clutch Switch
1 – 1 Clutch Switch
Optional
0 – Hardwired
255 – Not Configured
5-149