Detroit Diesel DDEC VI Application And Installation page 74

HARDWARE AND WIRING
The pin assignments for the Common Powertrain Controller (CPC) #3 connector (21–pins) for
truck applications islisted in Table 3-26 . The side of the connector shown is looking into the pins.
The part numbers for the #3 connector, Key A and terminals are listed in Table 3-27.
Pin Signal Type
3/1 Analog_In_01
3/2 Analog_GND
3/3 Analog__SUP_5V
3/4 Analog_In_02
3/5 Analog_Out_01
3/6 Analog_Out_02
3/7 Digital Output_HP_HS_01
3/8 Digital Output_HP_HS_02
3/9 Digital Output_HP_LS_01
3/10 Digital Output_LP_FLEX_02
3/11 SFP_14
3/12 Digital Output_LP_FLEX_04
3/13 SFP_09
3/14 SF_VGND
3/15 Analog_In_SFP_13
3/16 Digital Output_LP_FLEX_05
3/17 Digital Output_HP_FLEX_02
3/18 Digital Input_SFP_02
3/19 Not Used
3/20 Not Used
Not Used
3/21
Table 3-26 Connector #3 Pin Assignments – Truck Application
Part
CPC - 21 Pin Connector - A Key
CPC - socket 0.5-1.0mm wire (single)
CPC - socket 1.0-2.5mm wire (single)
Table 3-27 Connector #3, 21–pin Connector, Key A
3-36
Function
OI Thermostat
Sensor Return
Sensor Supply
PTO
Not Used
Not Used
Top2 Lockout Solenoid/AGS2 PTO Valve
Top2 Shift Solenoid/AGS2 PTO Lamp
AGS 2 Backup Lamp
AGS2 Trans Temp Lamp
Low Coolant Level Sensor
AGS2 Check Trans Lamp
Vehicle Speed (+)
Vehicle Speed (-)
Ambient Air Temperature Sensor
Red Stop Lamp
OI Alarm
ABS Active (AGS2 Transmission)
Not Populated
Not Populated
Not Populated
7SA827 0701 Copyright © 2007 DETROIT DIESEL CORPORATION
Connector
Front
Looking into the Pins on
the Harness
DDC Part Number
013 545 65 26
013 545 76 26
013 545 78 26
All information subject to change without notice. (Rev. 01/07)