Diagnostic Request Switch; Installation; Programming Requirements And Flexibility - Detroit Diesel DDEC VI Application And Installation

INPUTS AND OUTPUTS
4.1.7

DIAGNOSTIC REQUEST SWITCH

This digital input allows the flashing of diagnostic codes using the AWL and RSL. This is a
momentary normally open switch.

Installation

The Diagnostic Request Switch is wired to #1 connector of the CPC on pin 1/15.

Programming Requirements and Flexibility

The options for this digital input are listed in Table 4-8.
Parameter
Parameter
Group
1 15 DI
13
Selection
* Not supported in NAFTA
Table 4-8 Diagnostic Request Switch Programming Options
4-10
Options
0 – Disabled
1 – Stop Engine Override Switch
/Diagnostic Request Switch (fault
code flashing)
2 – CC Cancel (FUSO)*
3 – Diagnostic Request Switch
(fault code flashing)
7SA827 0701 Copyright © 2007 DETROIT DIESEL CORPORATION
Default
1 – Stop Engine Override Switch
/Diagnostic Request Switch (fault
code flashing)
All information subject to change without notice. (Rev. 01/07)
Access
VEPS or
DRS