Detroit Diesel DDEC VI Application And Installation page 194

INPUTS AND OUTPUTS
4.3.6 DECELERATION LAMP
The Deceleration Lamp options a lamp in the back of the vehicle to warn that the vehicle is
slowing down. This digital output could be used to drive a deceleration lamp or more typically a
relay which drives the deceleration lamps. This digital output is switched to ground whenever the
percent throttle is zero and Cruise Control is inactive.
NOTE:
This feature is optional.
Installation
This digital output circuit is designed to sink no more than 2.0 mA (DC) current. The Deceleration
Lamp is wired to pin 4/9 of the CPC.
Programming Requirements and Flexibility
The options for this digital output are listed in Table 4-32.
Parameter
Parameter
Group
4 09 DO
35
Selection
4 09
35 DO Fault
Detection
* Not supported in NAFTA
Table 4-32 Deceleration Lamp Programming Options
4-34
Setting
0 – Disabled
1 – Accelerator Pedal Idle
Position*
2 – Actual Torque*
3 – Road Speed*
4 – Engine Speed*
5 – Coolant Temp*
6 – Pedal Torque*
11 – Deceleration
7 – Boost Temp*
Lamp
8 – Oil Pressure (MCM
Threshold)*
9 – Coolant Temp (MCM
Threshold)*
10 – OI Active Lamp
11 – Deceleration Lamp
12 – FUSO Ground Starter
Lockout Relay*
0 — Disabled
—
1 — Enabled
7SA827 0701 Copyright © 2007 DETROIT DIESEL CORPORATION
Options Default
0 – Disabled
0 — Disabled
All information subject to change without notice. (Rev. 01/07)
Access
VEPS or
DRS
VEPS or
DRS