Figure 3-14 Setting Wire Gage Selector And Positioning The Contact; Figure 3-15 Pushing Contact Into Grommet - Detroit Diesel DDEC VI Application And Installation

Use the following instructions for installing Deutsch terminals:
1. Strip approximately .25 inch (6 mm) of insulation from the cable.
2. Remove the lock clip, raise the wire gage selector, and rotate the knob to the number
matching the gage wire that is being used.
3. Lower the selector and insert the lock clip.
4. Position the contact so that the crimp barrel is 1/32 of an inch above the four indenters.
See Figure 3-14. Crimp the cable.
Figure 3-14 Setting Wire Gage Selector and Positioning the Contact
5. Grasp the contact approximately one inch behind the contact crimp barrel. Hold the
connector with the rear grommet facing you. See Figure 3-15.
Figure 3-15 Pushing Contact Into Grommet
All information subject to change without notice. (Rev. 01/07)
7SA827 0701 Copyright © 2007 DETROIT DIESEL CORPORATION
DDEC VI ELECTRONIC CONTROLS APPLICATION AND INSTALLATION
3-75