Detroit Diesel DDEC VI Application And Installation page 191

4.3.2 AGS2 CHECK TRANS LAMP
This digital output is used for non-multiplexed applications with the AGS2 transmission.
Installation
This digital output circuit is designed to sink no more that 250 mA (DC) current.
The AGS2 Check Trans Lamp is wired to pin 3/12 of the CPC.
Programming Requirements and Flexibility
The options for this digital output are listed in Table 4-29.
Parameter
Parameter
Group
3 12 DO
35
Selection
3 12
35 DO Fault
Detection
* Not supported in NAFTA
Table 4-29 AGS2 Check Transmission Indication Lamp Programming Options
All information subject to change without notice. (Rev. 01/07)
7SA827 0701 Copyright © 2007 DETROIT DIESEL CORPORATION
DDEC VI ELECTRONIC CONTROLS APPLICATION AND INSTALLATION
Setting
0 – Disabled
1 – Oil Level Lamp
2 – AGS2 Check
2 – AGS2 Check Transmission Indication
Lamp
Transmission
Indication Lamp 3 – Oil Pressure Low Lamp
4 – Cruise Active Lamp
5 – FUSO Retarder Control
2*
0 – Disabled
—
1 – Enabled
Options Default
0 – Disabled
0 – Disabled
Access
VEPS or
DRS
VEPS or
DRS
4-31