Detroit Diesel DDEC VI Application And Installation page 364

FEATURES
Programming Requirements and Flexibility
AGS2 transmissions have additional programming requirements on non-multiplexed vehicles as
listed in Table 5-81.
Parameter
Group
2
35
35
35
35
MCM
1
13
Table 5-81 AGS2 Transmission Programming Requirements for Non-Multiplexed
Vehicles
AGS2 transmissions have additional programming requirements on multiplexed vehicles as
listed in Table 5-82.
Parameter
Group
2
35
MCM
1
13
* If starter type is not 0, then a different module must prevent the starter from engaging when the transmission
is in gear.
Table 5-82 AGS2 Transmission Programming Requirements for Multiplexed
Vehicles
5-152
Parameter
Transmission Type
3 09 DO Selection
3 10 DO Selection
3 12 DO Selection
3 17 DO Selection
Starter Type Control
Transmit EBC1 for AGS2
3 18 DI Selection
Parameter
Transmission Type
3 17 DO Selection
Starter Type Control
Transmit EBC1 for AGS2
3 18 DI Selection
7SA827 0701 Copyright © 2007 DETROIT DIESEL CORPORATION
Setting
DIRECT ENGINE START
2 – AGS2 Direct Start
MCM ENGINE START
5 – AGS2 MCM Start
2 – AGS2 Backup Lamp
2 – AGS2 Trans Temp Indicator Lamp
2 – AGS2 Check Trans Lamp
0 – Disabled
1 – Starter Activated via MCM
0 = No EBC1 (J1939 ABS)
1 = Transmit EBC1 (Non-J1939 ABS)
0 = Disable (J1939 ABS)
1 = Enable ABS Input (Non-J1939 ABS)
Setting
DIRECT ENGINE START
2 – AGS2 Direct Start
MCM ENGINE START
5 – AGS2 MCM Start
0 – Disabled
0 – Starter Activated via MCM*
0 = No EBC1 (J1939 ABS)
1 = Transmit EBC1 (Non-J1939 ABS)
0 = Disable (J1939 ABS)
1 = Enable ABS Input (Non-J1939 ABS)
All information subject to change without notice. (Rev. 01/07)