Detroit Diesel DDEC VI Application And Installation page 197

4.3.9 ETHER START
This digital output is switched to ground when ether should be injected into the engine for cold
start purposes.
NOTE:
This output is used on a Series 60 engine only.
Installation
This function is wired to pin 31/8 of the 31-pin connector. The power supply for the ether system
should be wired to pin 31/22 of the 31-pin connector.
Programming Requirements & Flexibility
The options for this digital input are listed in Table 4-35.
Parameter
Parameter
Group
SW6
MCM – 1
Configuration
MCM – 8 Cold Start Type
Table 4-35 Ether Start Options
All information subject to change without notice. (Rev. 01/07)
7SA827 0701 Copyright © 2007 DETROIT DIESEL CORPORATION
DDEC VI ELECTRONIC CONTROLS APPLICATION AND INSTALLATION
Options
0 – Disable
24 – Ether Start
0 – No Function
1 – Grid Heater
3 – Ether Injection
Default Access
0 - Disable VEPS, DRS
0 – No Function VEPS, DRS
4-37