Positioning The Leads; Securing The Leads With A Clip - Detroit Diesel EPA07 Series 60 DDEC VI Troubleshooting Manual

Soldering splice connectors is optional. To solder splice connectors:
1. Position the leads, so one overlaps the other. See Figure 17-14.
Figure 17-14

Positioning the Leads

2. Secure the leads with a commercially available clip and hand tool. See Figure 17-15.
Figure 17-15

Securing the Leads With a Clip

3. Use a suitable electronic soldering iron to heat the wires. Apply the solder to the heated
wire and clip (not to the soldering iron) allowing sufficient solder flow into the splice joint.
All information subject to change without notice.
Copyright © 2007 DETROIT DIESEL CORPORATION
SERIES 60 DDEC VI TROUBLESHOOTING GUIDE
17-27