HARDWARE AND WIRING
3.7.15
AGS2 TRANS TEMP LAMP
The AGS2 Trans Temp Lamp is controlled by DDEC VI..
The AGS2 Trans Temp Lamp remains ON:
□ For approximately five (5) seconds at the start of every ignition cycle
□ When transmission temp is high
AGS2 Trans Temp Lamp Requirements and Guidelines
The following requirements and guidelines apply to the AGS2 Trans Temp Lamp:
□ The AGS2 Trans Temp Lamp is optional.
□ A 12 volt light of less than 0.25 A (DC) is required depending on the ignition source.
Digital output circuits are designed to sink no more than 0.25 A (DC) current.
□ The AGS2 Trans Temp Lamp must be integrated into the instrument panel or placed in
clear view of the vehicle operator.
□ This output is wired to pin 3/10 of the CPC.
Programming Requirements and Flexibility
The options for this digital output are listed in Table 3-121.
Parameter
Parameter
Group
3 10 DO
35
Selection
3 10
35
DO Fault
Detection
* Not supported in NAFTA
Table 3-121
AGS2 Trans Temp Lamp Programming Options
3-122
(a bulb check)
Setting
0 = Disabled
2 = AGS2
1 = Air Filter Lamp*
Check
2 = AGS2 Transmission Temp Indication
Transmis-
Lamp
sion Indica-
3 = Battery Voltage Low Lamp
tion Lamp
4 = Coolant Level Low Lamp
5 = FUSO Retarder Control 1*
0 = Disabled
–
1 = Enabled
7SA827 0701 Copyright © 2007 DETROIT DIESEL CORPORATION
Options
All information subject to change without notice. (Rev. 01/07)
Default
Access
0 =
VEPS or
Disabled
DRS
0 =
VEPS or
Disabled
DRS