Lamps; Amber Warning Lamp; Awl And Passmart; Amber Warning Lamp Requirements And Guidelines - Detroit Diesel DDEC VI Application And Installation

Table of Contents

Advertisement

3.7

LAMPS

The instrument panel warning lamps, the Amber Warning Lamp (AWL) and the Red Stop
Lamp (RSL), are supplied by the OEM. The functionality of each lamp along with the wiring
requirements are covered separately in the following sections.
3.7.1

AMBER WARNING LAMP

The AWL is controlled by DDEC VI.
The AWL remains ON:
□ For approximately five (5) seconds at the start of every ignition cycle
□ When an electronic system fault occurs (This indicates the problem
The AWL flashes:
□ When the Diagnostic Request Switch is used to activate the AWL to flash inactive codes
□ During last 90 seconds before Idle Shutdown if programmed for override
□ When Idle Shutdown occurs or the Optimized Idle system shutdown occurs

AWL and PasSmart

AWL is active with PasSmart. When the Passing Speed Duration time expires, the Amber
Warning Lamp on the dashboard will begin to flash one minute prior to ramping the Vehicle Limit
Speed (VLS) back down to the normal VLS limit. The rampdown event always takes 5 seconds
regardless of the Passing Speed Increment programmed into the ECU. The rampdown alert
can be distinguished from an engine fault warning in that the AWL flashes for the former and
remains on constantly for the latter.
PasSmart still operates when there is an active engine fault. In this situation the Amber Warning
Lamp goes from constant illumination to flashing one minute before the VLS limit ramps down.
At the end of the passing event when PasSmart is deactivated, the Amber Warning Lamp will
return to constant illumination if the engine fault is still active.

Amber Warning Lamp Requirements and Guidelines

The following requirements and guidelines apply to the AWL:
□ The AWL is required.
□ A 12 volt light of less than 0.25 A (DC) is required depending on the ignition source.
□ The AWL must be integrated into the instrument panel or placed in clear view of the
equipment operator.
□ The lens color must be amber.
All information subject to change without notice. (Rev. 01/07)
7SA827 0701 Copyright © 2007 DETROIT DIESEL CORPORATION
DDEC VI ELECTRONIC CONTROLS APPLICATION AND INSTALLATION
(a bulb check)
should be diagnosed as soon as possible.)
3-107

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents