Optimized Idle Thermostat; Installation; Programming Requirements And Flexibility - Detroit Diesel DDEC VI Application And Installation

4.1.16

OPTIMIZED IDLE THERMOSTAT

The OI thermostat input indicates when the engine should run to heat/cool the cab when operating
in Optimized Idle mode. This input is normally open.

Installation

The OI thermostat is wired to the CPC on pin 3/1.

Programming Requirements and Flexibility

The options for this digital input are listed in Table 4-15.
Parameter
Parameter
Group
13 3 01 AI Selection
* Not supported in NAFTA
Table 4-15 OI Thermostat Programming Options
All information subject to change without notice. (Rev. 01/07)
7SA827 0701 Copyright © 2007 DETROIT DIESEL CORPORATION
DDEC VI ELECTRONIC CONTROLS APPLICATION AND INSTALLATION
Options
0 = No Sensor
1 = Air Filter Restriction Sensor*
2 = OI Thermostat
3 = FUSO Clutch Pedal Sensor
Input*
Default Access
0 = No Sensor VEPS, DRS
4-17