Figure 3-8 Cpc Dimensions - Detroit Diesel DDEC VI Application And Installation

HARDWARE AND WIRING
The OEM is responsible for mounting this part in an enclosed, protected environment. The
mounting bracket is the responsibility of the OEM. There must be maximum physical separation
of the VIH from other vehicle/equipment electrical systems. Other electrical system wires should
ideally be at least three feet away from the VIH and should not be parallel to the VIH. This will
eliminate coupling electromagnetic energy from other systems into the VIH. See Figure 3-8 for
the CPC dimensions.
Figure 3-8 CPC Dimensions
NOTE:
The CPC should be mounted with the connectors pointing down.
3-28
All information subject to change without notice. (Rev. 01/07)
7SA827 0701 Copyright © 2007 DETROIT DIESEL CORPORATION