Positioning The Leads; Securing The Leads With A Clip - Detroit Diesel Series 60 DDEC VI Troubleshooting Manual

Soldering splice connectors is optional. To solder splice connectors:
1. Position the leads, so one overlaps the other. See Figure 2-14.
Figure 2-14

Positioning the Leads

2. Secure the leads with a commercially available clip and hand tool. See Figure 2-15.
Figure 2-15

Securing the Leads With a Clip

3. Use a suitable electronic soldering iron to heat the wires. Apply the solder to the heated
wire and clip (not to the soldering iron) allowing sufficient solder flow into the splice joint.
All information subject to change without notice.
PRELIMINARY 6SE567 0512 Copyright © 2005 DETROIT DIESEL CORPORATION
DDEC VI SERIES 60 TROUBLESHOOTING GUIDE
2-31