Detroit Diesel DDEC VI Application And Installation page 193

4.3.5 CRUISE ACTIVE LAMP
When Cruise Control's Cruise Switch PTO is active, this digital output is switched to ground.
This digital output can be used to drive a lamp indicating the active state of Cruise Control.
NOTE:
This function is optional.
Installation
This digital output circuit is designed to sink no more that 250 mA (DC) current. The Cruise
Active Lamp is wired to pin 3/12 of the CPC.
Programming Requirements and Flexibility
The options for this digital output are listed in Table 4-31.
Parameter
Parameter
Group
35
3 12 DO Selection
3 12 DO Fault
35
Detection
* Not supported in NAFTA
Table 4-31 Cruise Active Lamp Programming Options
All information subject to change without notice. (Rev. 01/07)
7SA827 0701 Copyright © 2007 DETROIT DIESEL CORPORATION
DDEC VI ELECTRONIC CONTROLS APPLICATION AND INSTALLATION
Setting Options
0 — Disabled
1 – Oil Level Lamp*
4 — Cruise 2 — AGS2 Check Trans Lamp
Active Lamp 3 — Oil Pressure Low Lamp
4 — Cruise Active Lamp
5 — FUSO Retarder Control 2*
0 — Disabled
—
1 — Enabled
Default Access
VEPS or
0 — Disabled
DRS
VEPS or
0 — Disabled
DRS
4-33