Crane Applications - Detroit Diesel DDEC VI Application And Installation

HARDWARE AND WIRING

Crane Applications

The pin assignments for the Common Powertrain Controller #1 connector (18–pin) for crane
applications are listed in Table 3-54.
The part numbers for the #1 connector, Key B and terminals are listed in Table 3-55.
Pin Signal Type
Digital Input_FLEX_01
1/1
1/2 Digital Input_FLEX_02
1/3 Digital Input_SFP_05
1/4 Digital Output_LP_LS_02
1/5 Digital Output_LP_LS_01
1/6 Digital Input_SFP_06
1/7 SFP_08
1/8 SFP_07
1/9 PWM_FPO_02
1/10 Digital Input_FLEX_20
1/11 Digital Input_FLEX_08
1/12 Digital Input_FLEX_03
1/13 Digital Output_LP_FLEX_01
1/14 Digital Input_FLEX_04
1/15 Digital Input_FLEX_05
1/16 Digital Input_FLEX_06
1/17 Digital Input_FLEX_07
1/18 SFP_01
Table 3-54 Connector #1 Pin Assignments – Crane Application
Part
CPC - 18 Pin Connector - B Key
CPC - socket 0.5-1.0mm wire (single)
CPC - socket 1.0-2.5mm wire (single)
Table 3-55 Connector #1, 18–pin Connector, B Key
3-50
Function
Transmission Retarder Active
Park Brake Interlock
Idle Validation Switch 2 (throttle active)
Throttle Position Sensor Ground
DPF Regeneration Lamp
Idle Validation Switch 1 (idle active)
Throttle Position Sensor
Throttle Position Sensor Supply
Not Used
Stop Engine / Aux Shutdown #1
Limiter 0
Set / Coast Enable
MIL Lamp
Cruise Control Enable
Stop Engine Override
Resume / Accel Enable
Throttle Inhibit
Run Start
7SA827 0701 Copyright © 2007 DETROIT DIESEL CORPORATION
Connector
Front
Looking into the Pins on
the Harness
DDC Part Number
018 545 67 26
013 545 76 26
013 545 78 26
All information subject to change without notice. (Rev. 01/07)