Ags2 Check Trans Lamp; Ags2 Check Trans Lamp Requirements And Guidelines; Programming Requirements And Flexibility - Detroit Diesel DDEC VI Application And Installation

3.7.14

AGS2 CHECK TRANS LAMP

The AGS2 Check Trans Lamp is controlled by DDEC VI..
The AGS2 Check Trans Lamp remains ON:
□ For approximately five (5) seconds at the start of every ignition cycle
□ When the AGS2 transmission ECU sends a diagnostic trouble code

AGS2 Check Trans Lamp Requirements and Guidelines

The following requirements and guidelines apply to the AGS2 Check Trans Lamp:
□ The AGS2 Check Trans Lamp is optional.
□ A 12 volt light of less than 0.25 A (DC) is required depending on the ignition source.
Digital output circuits are designed to sink no more than 0.25 A (DC) current.
□ The AGS2 Check Trans Lamp must be integrated into the instrument panel or placed in
clear view of the vehicle operator.
□ This output is wired to pin 3/12 of the CPC.

Programming Requirements and Flexibility

The options for this digital output are listed in Table 3-120.
Parameter
Parameter
Group
3 12 DO
35
Selection
3 12
35 DO Fault
Detection
* Not supported in NAFTA
Table 3-120 AGS2 Check Trans Lamp Programming Options
All information subject to change without notice. (Rev. 01/07)
7SA827 0701 Copyright © 2007 DETROIT DIESEL CORPORATION
DDEC VI ELECTRONIC CONTROLS APPLICATION AND INSTALLATION
(a bulb check)
with an SPN 2003
Setting
0 = Disabled
2 = AGS2 1 = Oil Level Lamp
Check 2 = AGS2 Check Transmission Indication
Transmis- Lamp
sion Indica- 3 = Oil Pressure Low Lamp
tion Lamp 4 = Cruise Active Lamp
5 = FUSO Retarder Control 2*
0 = Disabled
–
1 = Enabled
Options
Disabled
Disabled
Default Access
0 =
VEPS or
DRS
0 = VEPS or
DRS
3-121