Detroit Diesel DDEC VI Application And Installation page 327

Programming Requirements and Flexibility
The parameters listed in Table 5-64 must be set for manual transmissions.
Parameter
Group
13 Clutch Switch Config
13
13 Trans Neutral Input Config
13 Park Brake Switch Config
13
8
Vehicle Speed Sensor
Table 5-64 Parameter Settings for Manual Transmissions
The parameters listed in Table 5-65 must be set for Allison, Eaton UltraShift transmissions.
Parameter
Group
13 Clutch Switch Config
13
13 Trans Neutral Input Config
13 Park Brake Switch Config
13
8 Vehicle Speed Sensor
Table 5-65 Parameter Settings for J1939 Transmissions (Allison, Eaton
UltraShift, Eaton AutoShift)
The parameter listed in Table 5-66 is optional for hazardous applications.
Parameter
Parameter
Group
DPF Stationary
46
Regen only
Table 5-66 DPF Stationary Regen Only Parameter
All information subject to change without notice. (Rev. 01/07)
7SA827 0701 Copyright © 2007 DETROIT DIESEL CORPORATION
DDEC VI ELECTRONIC CONTROLS APPLICATION AND INSTALLATION
Parameter
4 08 DI Selection
1 02 DI Selection
Parameter
4 08 DI Selection
1 02 DI Selection
Description
0 – DPF Regen Switch can
request parked regen or
over-the-road regen
1 – DPF Regen Switch can
request parked regen only.
Setting
1 – 1 Clutch Switch
1 – 1 Clutch Switch
0 – Hardwired
255 – Not Available (typical setting)
0 – Hardwired (typical setting)
1 – CCVS1
2 – CCVS2
3 – CCVS3
1 – Enable Park Brake Interlock
4 – Magnetic Pickup Vehicle Speed Sensor
Setting
0 – No Clutch Switch
0 – Disable
1 – Info from J1939
0 – Hardwired (typical setting)
1 – CCVS1
2 – CCVS2
3 – CCVS3
1 – Enable Park Brake Interlock
3 – J1939 ETCI
Default
1 – Enabled
Access
VEPS, DRS
5-115