Detroit Diesel DDEC VI Application And Installation page 306

FEATURES
5.15.4 PROGRAMMING REQUIREMENTS AND FLEXIBILITY
All the Idle Shutdown timer options are listed in Table 5-49.
Parameter
Parameter
Group
1 02 DI
13
Selection
Park Brake
13
Switch Config
Enable Idle
17
Shutdown
Idle Shutdown
17
Time
Enable PTO
17
Shutdown
PTO
17 Shutdown
Time
Min Coolant
17
Temp
Enable Idle
17 PTO Shtdn
Override
Max Engine
17 Load PTO
Shutdown
5-94
Description
0 = Disabled
Configure pin 1 = Enable Park Brake Interlock
2 = FUSO Auxiliary Brake Cut
1/02 on CPC
Switch*
0 = Hardwired
Park Brake 1 = CCVS1
Configuration 2 = CCVS2
3 = CCVS3
0 = Disable
Enables or
1 = Enable with Park Brake
Disables the
2 = Enable without Park Brake
Idle Shutdown
3 = Enabled with Edge Triggered
feature.
Accel Pedal
The amount of
engine idle time
that is allowed
before the
1 to 5000 seconds
Idle Shutdown
feature stops
fueling the
engine.
Enables or
0 = Disable
disables the Idle
1 = Enable with Park Brake
Timer Shutdown
2 = Enable without Park Brake
feature when
3 = Enabled with Edge Triggered
operating in PTO
Accel Pedal
mode.
The amount of
engine idle time
that is allowed
before the PTO 1 to 5000 seconds
shutdown feature
stops fueling the
engine.
Minimum coolant
temperature
before an idle
shutdown will
occur
0 = Disable
1 = Enabled, allows
Enables/disables SEO/Diagnostic Request Switch
override of Idle or to override Engine Idle/PTO
PTO Shutdown Shutdown
2 = Enable without clutch and
service brake
PTO shutdown
disabled for
engine loads
greater than this
value
7SA827 0701 Copyright © 2007 DETROIT DIESEL CORPORATION
Options
1 = Enable Park
Brake Interlock
0 = Hardwired
-40°C to 200°C
1 = Enabled,
allows
SEO/Diagnostic
Request Switch
to override
Engine Idle/PTO
Shutdown
0–5000 Nm
All information subject to change without notice. (Rev. 01/07)
Default Access
VEPS,
DRS
VEPS,
DRS
DDDL
0 = Disable 7.0, DRS,
VEPS
DDDL
60 sec 7.0, DRS,
VEPS
DDDL
0 = Disable 7.0, DRS,
VEPS
DDDL
60 sec 7.0, DRS,
VEPS
VEPS,
10°C
DRS
DDDL
7.0, DRS,
VEPS
VEPS,
100 Nm
DRS