Crimp Tools; Deutsch Terminal Installation And Removal; Deutsch Terminal Installation Guidelines - Detroit Diesel DDEC VI Application And Installation

HARDWARE AND WIRING
3.3.3

CRIMP TOOLS

The part numbers for the crimp tools for working with the MCM and CPC connectors are
listed in Table 3-91.
Description
Extraction Tool
Hand Crimp Tool
Crimp Dies for 0.5 mm – 1.0 mm Terminals
Crimp Dies for 1.0 mm – 2.5 mm Terminals
Table 3-91 Crimp Tools
3.3.4

DEUTSCH TERMINAL INSTALLATION AND REMOVAL

The method of terminal installation and removal varies. The following sections cover Deutsch
terminal installation and removal.

Deutsch Terminal Installation Guidelines

Deutsch connectors have cable seals molded into the connector. These connectors are push-to-seat
connectors with cylindrical terminals. The diagnostic connector terminals are gold plated for
clarity.
Improper selection and use of crimp tools have varying adverse
effects on crimp geometry and effectiveness. Proper installation
of terminals require specialized tools. Do not attempt to use
alternative tools.
The crimp tool to use in Deutsch terminal installation is J–34182 (Kent-Moore part number).
Terminal crimps must be made with the Deutsch crimp tool P/N:
HDT-48-00 to assure gas tight connections.
If a separate seal is required, be sure to install the seal onto the
wire before stripping the insulation.
3-74
Part Number
NOTICE:
NOTICE:
NOTICE:
All information subject to change without notice. (Rev. 01/07)
7SA827 0701 Copyright © 2007 DETROIT DIESEL CORPORATION
726503–1
169400–0
734262–0
169917–0