Splicing And Repairing Straight Leads-Alternate Method 1 - Detroit Diesel DDEC VI Application And Installation

HARDWARE AND WIRING
4. Pull on wire to assure crimping and soldering integrity. The criteria listed in Table 3-94
must be met.
Wire Gage
14 AWG
16 AWG
18 AWG
Table 3-94 Applied Load Criteria for Terminals
5. Loop the lead back over the spliced joint and tape. See Figure 3-21.
Figure 3-21 Recommended Strain Relief of Spliced Joint

Splicing and Repairing Straight Leads-Alternate Method 1

The tools required are listed in Table 3-95.
Tool
Heat Gun
Wire Stripper
Splice Clips (commercially available)
Heat Shrink Tubing
Terminal Crimper for Metri-Pack 280 (12 AWG)
Terminal Crimper for Metri-Pack 280 (18 AWG)
Terminal Crimper for Weather Pack
Terminal Crimper for Deutsch
Terminal Crimper for Metri-Pack 150
Table 3-95 Recommended Splicing Tools
3-80
Must Withstand Applied Load
45 lb (200 N)
27 lb (120 N)
20 lb (90 N)
Part Number
--
Kent-Moore J–35615 or equivalent
Wire size dependent
Raychem HTAT or equivalent
Kent-Moore J–38125-6
Kent-Moore J–39848
Kent-Moore J–35606
Kent-Moore J–34182
Kent-Moore J–35123
All information subject to change without notice. (Rev. 01/07)
7SA827 0701 Copyright © 2007 DETROIT DIESEL CORPORATION