Installation; Programming Requirements And Flexibility - Detroit Diesel DDEC VI Application And Installation

INPUTS AND OUTPUTS
4.1.5 CRUISE CONTROL ON/OFF SWITCH
Cruise Control is enabled but not active when the Cruise Control Master switch digital input is
switched to battery ground.
The Cruise Control Master switch is a normally open switch.

Installation

The Cruise Control Master Switch is wired to the CPC on pin 1/14. Alternatively, this input may
be multiplexed on J1939. Refer to section 4.2, "Switch Inputs Received Over J1939 Data Link"
for additional information on multiplexing this input.

Programming Requirements and Flexibility

The options for this digital input are listed in Table 4-6.
Parameter Group
CC ON OFF Switch
13
Table 4-6 Cruise Control On/Off Switch Programming Options
4-8
Parameter Options
0 – Hardwired
1 – CCVS1
Config 2 – CCVS2
3 – CCVS3
7SA827 0701 Copyright © 2007 DETROIT DIESEL CORPORATION
Default Access
0 – Hardwired VEPS or DRS
All information subject to change without notice. (Rev. 01/07)