Detroit Diesel DDEC VI Application And Installation page 235

Min Vehicle Speed for Engine Brakes
This option will disable the engine brakes until a minimum vehicle speed is reached. A Vehicle
Speed Sensor (VSS) is required. Refer to section 3.6.6, "Vehicle Speed Sensor," for additional
information.
5.6.2 PROGRAMMING REQUIREMENTS AND FLEXIBILITY
Engine Brake must be specified at the time of engine order or by contacting Detroit Diesel
Technical Service.
Configuration for MBE900 Exhaust Flap Applications
The MCM Exhaust Flap configuration parameters are listed in Table 5-12.
MCM
Parameter
Parameter
Group
PWM7
1
Configuration
SW4
2
Configuration
Table 5-12 MCM Configuration Parameter for Exhaust Flap Applications -
MBE900 Engine
The CPC Exhaust Flap configuration parameters are listed in Table 5-13.
CPC
Parameter Parameter
Group
Engine Brake
10
Configuration
Stage 1 Mask
10
Engine Brake
All information subject to change without notice. (Rev. 01/07)
7SA827 0701 Copyright © 2007 DETROIT DIESEL CORPORATION
DDEC VI ELECTRONIC CONTROLS APPLICATION AND INSTALLATION
Setting
0 – No Function 6 – Jake Brake 1 or
Decompression Valve
7 – Jake Brake 2
or Exhaust Flap 7 – Jake Brake 2 or Exhaust
or Brake Gate Flap or Brake Gate
Description
0 = No Engine Brake
1 = Decompression Valve Only or
Enables the
Exhaust Flap Only
type of engine
2 = Decompression Valve & Exhaust Flap
brake required
3 = Jake Compression Brake or Brake
Gate
0 = No Engine Brake
16 = Exhaust Flap Only
Mask 17 = Jake Brake 2nd Stage
determines 64 = Decompression Valve Only or Jake
which device Brake 1st Stage
turns on for 80 = Decompression Valve & Exhaust
low braking Flap
81 = Decompression Valve & Brake Gate
or Jake Brake 3rd Stage
Options Default
0 – No Function
0 – No Function
0 – No Function
0 – No Function
Options
Access
VEPS or
DRS
VEPS or
DRS
Setting Access
VEPS or
1
DRS
VEPS or
0
DRS
5-23