TN2302AP Amphenol Adapter
Figure notes
1
Amphenol connector to backplane
connector corresponding to
TN2302AP slot
Installing the TN2302AP IP Media Processor
Connect the cables for TN799DP
1
Determine into which port slots you are putting the TN799DP C-LAN circuit packs.
From the rear of the media gateway:
Connect a 259A connector to the Amphenol connector corresponding to each TN799DP
2
slot.
Connect one end of each DW8 cable to each 259A connector.
3
Connect the cables for TN2302AP
1
Determine into which port slots you are putting the TN2302AP IP Media Processor
circuit packs.
From the rear of the media gateway:
2
Connect the amphenol connector on the adapter to the Amphenol connector
corresponding to each TN2302AP slot.
Connect the Ethernet
Connect the network cable(s) to the ETHERNET connector on the TN2302AP backplane
1
adapter(s).
NOTE:
You need a CAT5 or better cable for 100-Mbyte operation.
3
1
addfipm2 KLC 083000
2
3
May 2002
Installing the S8700 Multi-Connect
Connecting to the Customer's Network
2
To network
9-pin connector for
maintenance
173