6E1-84 ELECTRONIC FUEL INJECTION SYSTEM (G13/G16 ENGINE WITHOUT WU TWC)
1. Grommet
2. O-ring
3. Cushion
1. O-ring
2. Grommet
3. Insulator
INSTALLATION
For installation, reverse removal procedure and note the following
precautions.
Replace injector O-ring with new one using care not to damage
it.
Check if cushion is scored or damaged. If it is, replace with new
one.
Apply thin coat of fuel to O-rings and then install injectors into de-
livery pipe and intake manifold.
Make sure that injectors rotate smoothly. If not, probable cause
is incorrect installation of O-ring. Replace O-ring with new one.
Tighten delivery pipe bolts and make sure that injectors rotate
smoothly.
With engine "OFF" and ignition switch "ON", check for fuel leaks
around fuel line connection.