Suzuki Baleno Manual page 1719

B-7 ENGINE START SIGNAL CHECK
With ignition switch OFF,
disconnect couplers from ECM.
Is 6 – 12V voltage applied to
A11 terminal of coupler only
when cranking engine.
B-8 TRANSMISSION RANGE SIGNAL
("R", "D", "2", OR "L" RANGE SIGNAL) CIRCUIT CHECK
(4 A/T VEHICLE ONLY)
STEP
1) With ignition switch OFF, disconnect couplers from ECM.
2) Turn ignition switch ON and check voltage at C14 terminal
of coupler under each condition given below.
Selector lever in "P" or "N" range position: 10 – 14V
1
Selector lever in "R", "D", "2" or "L" range position: 0 – 1.5V
Is check result satisfactory?
Fig. for STEP 1
ELECTRONIC FUEL INJECTION SYSTEM (G13/G16 ENGINE WITHOUT WU TWC) 6E1-55
1. ECM coupler
disconnected
2. Body ground
ACTION
1. ECM coupler disconnected
2. Body ground
1. ECM (PCM)
2. ECM (PCM) coupler
3. Transmission range switch (A/T)
4. Main switch
5. To starting motor
YES
Engine start signal circuit is in good
condition.
D Wire open
NO
D Poor connection or
D Faulty transmission range switch (A/T).
1. ECM
2. ECM coupler
3. TCM
YES
Signal circuit is in D Wire open
good condition. D Poor connection
NO
If wire and
connection are
OK, check A/T
control system
referring to
Section 7B1.