Suzuki Baleno Manual page 1663

6C-8 ENGINE FUEL
1. Fuel pump 2. Fuel level gauge
1. Fuel filler hose 3. Clamp
2. Breather hose 4. Filler neck
1. Return hose
2. Vapor hose 3. Feed hose
FUEL TANK PURGING PROCEDURE
WARNING:
This purging procedure will NOT remove all fuel vapor.
Do not attempt any repair on tank using heat or flame as
an explosion resulting in personal injury could occur.
The following procedure is used for purging fuel tank.
1) After removing fuel tank, remove all hoses, pipes, fuel cut
valves, fuel pump and fuel level gauge from fuel tank.
2) Drain all remaining fuel from tank.
3) Move tank to flushing area.
4) Fill tank with warm water or tap water, and agitate vigorously
and drain. Repeat this washing until inside of tank is clean.
Replace tank if its inside is rusty.
5) Completely flush out remaining water after washing.
CAUTION:
Never remain water in fuel tank after washing, or fuel
tank inside will get corrosion.
INSTALLATION
1) Install fuel pump and fuel level gauge to fuel tank.
Use new gaskets.
2) Connect fuel hoses and pipes to fuel tank referring to "FUEL
SYSTEM" of "GENERAL DESCRIPTION" in this section.
Clamp hoses and wire harness securely.
3) Connect fuel breather hose to fuel tank.
4) Install fuel tank to vehicle.
5) Connect fuel filler hose to tank and breather hose to filler neck
as shown in figure and clamp them securely.
6) Connect fuel and vapor hoses to pipes as shown in figure and
clamp them securely.