Suzuki Baleno Manual page 1682

6E1-18 ELECTRONIC FUEL INJECTION SYSTEM (G13/G16 ENGINE WITHOUT WU TWC)
1. Data link connector (DLC)
DTC DTC
Lamp
No.21 No.21
turn
ON
OFF
1. Malfunction indicator lamp
2. Diagnosis connector-1
3. Diagnosis terminal
4. Ground terminal
DIAGNOSTIC TROUBLE CODE(S) CHECK
[Using SUZUKI scan tool]
1) Turn ignition switch OFF.
2) After setting cartridge to SUZUKI scan tool, connect it to data
3) Turn ignition switch ON.
4) Read DTC according to instructions displayed on SUZUKI scan
5) After completing the check, turn ignition switch OFF and discon-
[Not using SUZUKI scan tool]
1) Using service wire, ground diagnosis switch terminal in diagno-
2) Read DTC from flashing pattern of malfunction indicator lamp
3) After completing the check, turn ignition switch OFF and discon-
DTC
No.21
sec.
("CHECK ENGINE" light)
link connector (DLC) located on underside of instrument panel
at driver's seat side.
Special Tool
(A): 09931-76011 (SUZUKI scan tool)
(B): Mass storage cartridge
(C): 09931-76030 (16/14 pin DLC cable)
tool and print it or write it down. Refer to SUZUKI scan tool oper-
ator's manual for further details.
nect SUZUKI scan tool from data link connector (DLC).
sis connector-1.
("CHECK ENGINE" light). (Refer to "DIAGNOSTIC TROUBLE
CODE TABLE" in this section.)
If DTC is not indicated by flashing malfunction indicator lamp
("CHECK ENGINE" light), perform "DIAGNOSTIC FLOW
TABLE" in this section.
nect service wire from diagnosis connector-1.