Suzuki Baleno Manual page 1581

6A3-42 ENGINE MECHANICAL (J18 TYPE ENGINE)
1. Match mark on crank timing sprocket
2. Timing mark on lower crank case
1. Crankshaft
2. Crankshaft timing sprocket
3. Cylinder block
1. Idler sprocket
2. Match mark on idler sprocket
1. Crankshaft timing sprocket
2. Match mark
1. Timing chain tensioner
2. Spacer
INSTALLATION
1) Check that match mark on crankshaft timing sprocket is in
match with timing mark on lower crankcase.
2) Install crankshaft timing sprocket as shown in figure.
3) Apply oil to bush of idler sprocket.
4) Install idler sprocket and sprocket shaft.
5) Install 1st timing chain by aligning dark blue plate of 1st timing
chain and match mark on idler sprocket.
3. 1st timing chain
4. Dark blue plate
6) Bring yellow plate of 1st timing chain into match with match
marks on crankshaft timing sprocket.
3. 1st timing chain
4. Yellow plate
7) Install timing chain tensioner as shown in figure.
Tightening Torque
(a): 25 N·m (2.5 kg-m, 18.0 lb-ft)