Suzuki Baleno Manual page 1480

6A1-20 ENGINE MECHANICAL (G13/G16 TYPE ENGINE)
1. Tensioner bolt
2. Tensioner
2) Install tensioner and tensioner plate:
Do not tighten tensioner bolt with wrench yet. Hand tighten only
at this time.
Check to ensure that plate movement in arrow direction as
shown in figure causes tensioner to move in the same direction.
If no associated movement between plate and tensioner oc-
curs, remove tensioner and plate again and reinsert plate lug
into tensioner hole.
3. Tensioner plate
3) Check that timing mark on camshaft timing belt pulley is aligned
with "V" mark on cylinder head cover. If not, align two marks by
turning camshaft but be careful not to turn it more than its allow-
able turning range which is described on previous page.
1. "V" mark
2. Timing mark
by "E"
4) Check that punch mark on crankshaft timing belt pulley is
aligned with arrow mark on oil pump case. If not, align two marks
by turning crankshaft but be careful not to turn it more than its
allowable turning range which is described on previous page.
1. Arrow mark
2. Punch mark
5) Install timing belt and tensioner spring.
With two sets of marks aligned and tensioner plate pushed up,
install timing belt on two pulleys in such a way that drive side of
belt is free from any slack.
And then install tensioner spring as shown in figure, and hand-
tighten tensioner stud.
NOTE:
D When installing timing belt, match arrow mark ( ê ) on
timing belt with rotating direction of crankshaft.
D In this state, No.4 piston is at top dead center of com-
pression stroke.
1. Drive side of belt
2. Tensioner spring
3. Tensioner stud