Suzuki Baleno Manual page 1659

6C-4 ENGINE FUEL
1. Clamp
2. Clamp position
mark
3. Pipe cover
FUEL PIPE
REMOVAL
1) Relieve fuel pressure in fuel feed line referring to SECTION 6.
2) Disconnect negative cable at battery.
3) Disconnect fuel hose from fuel pipe at the front and rear of each
fuel pipe.
WARNING:
A small amount of fuel may be released after fuel hose
is disconnected. In order to reduce the chance of per-
sonal injury, cover hose and pipe to be disconnected
with a shop cloth. Be sure to put that cloth in an ap-
proved container when disconnection is completed.
4) Disconnect brake pipe from pipe joint referring to SECTION 5.
5) Remove pipe cover from body.
6) Put clamp position mark on pipes so that clamps can be
installed on original position.
7) Remove pipes with clamp from body.
8) Remove clamp from pipes.
INSTALLATION
1) Install clamps to marked position on pipes. If clamp is deformed
or its claw is bent or broken, replace it with a new one.
2) Install pipes with pipe clamp to body.