Suzuki Baleno Manual page 1568

1. Crankshaft pulley
2. Bolt
3. Wrench
1. Crankshaft pulley
1. Mounting member
2. Engine front torque bush
3. Engine rear mounting
4. Suspension frame
5. Front member
1. A/C compressor bracket
ENGINE MECHANICAL (J18 TYPE ENGINE) 6A3-29
8) Remove crankshaft pulley bolt.
To lock crankshaft pulley, use special tool (camshaft pulley
holder) with it as shown in figure.
Special Tool
(A): 09917-68221
CAUTION:
Be sure to use the following bolt for fixing special
tool to crankshaft pulley.
Bolt size: M8, P1.25 = 25 mm (0.98 in.)
Strength: 7T
9) Remove crankshaft pulley.
To remove crankshaft pulley, use special tools (Steering wheel
remover, Bearing puller attachment) with it as shown in figure.
Special Tools
(A): 09944-36011
(B): 09926-58010
10) Remove oil pan.
Refer to item "OIL PAN AND OIL PUMP STRAINER" in this
section for removal.
11) To facilitate work in the following steps, reinstall mounting
member and tighten fixing bolts to front member and suspen-
sion frame only.
Also, keep engine supported by lifting device.
12) With hoses connected, detach A/C compressor from compres-
sor bracket.
NOTE:
Suspend removed A/C compressor at a place free from
any possible damage during removal and installation of
timing chain cover.
13) Remove A/C compressor bracket.