Suzuki Baleno Manual page 1492

6A1-32 ENGINE MECHANICAL (G13/G16 TYPE ENGINE)
1. Valve adjusting screw
2. Lock nut
3. Rocker arm
1. Oil gallery plug
2. Timing belt
inside cover
4) Disconnect CMP sensor coupler from CMP sensor.
5) Disconnect high tension cords and couplers from ignition coil
1. CMP sensor case
2. Ignition coil assembly
6) After loosening all valve adjusting screw lock nuts, turn adjust-
7) Remove camshaft housing and camshaft.
8) Remove timing belt inside cover.
9) Remove intake rocker arm with clip from rocker arm shaft.
1. Rocker arm (IN)
2. Clip
3. Rocker arm shaft
assemblies and then remove ignition coil assembly of exhaust
manifold side.
Remove CMP sensor case from cylinder head.
Place a container or rag under CMP sensor case, for a small
amount of oil flows out during removal of case.
ing screws back all the way to allow all rocker arms to move free-
ly.
NOTE:
To remove camshaft housing bolts, loosen them in such or-
der as indicated in figure, a little at a time.
NOTE:
Do not bend clip when removing intake rocker arm.