6A3-30 ENGINE MECHANICAL (J18 TYPE ENGINE)
1. Electric lead wire
2. Clamp
3. Engine RH mounting
1. Generator belt idler pulley
2. Water pump pulley
3. Generator belt tensioner
14) Disconnect P/S oil tank from body.
15) Disconnect electric lead wire couplers (heated oxygen sensor
and A/C magnet clutch) and release clamps.
16) Using lifting device, raise engine till engine RH mounting be-
comes free from force applied to it and remove engine RH
mounting.
17) Using lifting device, raise engine enough to allow removal of
water pump pulley, generator belt idler pulley and generator
belt tensioner and remove them.
18) Remove cylinder head cover.
19) Remove timing chain cover bolts and nut.
20) Using lifting device, raise engine enough to allow removal of
timing chain cover and remove it.
1. Timing chain
cover
After removing timing chain cover, lower engine till front torque
2. Nut
3. Bolt
bush and rear mounting are set onto mounting member.
CLEAN
D Clean sealing surface on timing chain cover, crank case, cylin-
der block and cylinder head.
Remove oil, old sealant, and dust from sealing surface.
INSPECTION
D Check oil seal lip for fault or other damage.
Replace as necessary.
NOTE:
When installing new oil seal, top it in until its surface is flash
with edge of timing chain cover.
To install oil seal, use special tool (bearing installer).
Special Tool
1. Timing chain cover
(A): 09913-75510
2. Oil seal
CAUTION:
Be careful not to raise engine excessively and not to
cause transmission to contact body, steering gear
box, etc.
CAUTION:
Be careful not to raise engine excessively and not to
cause transmission to contact body, steering gear
box, etc.