Suzuki Baleno Manual page 1565

6A3-26 ENGINE MECHANICAL (J18 TYPE ENGINE)
1. Oil pump case No.1
2. Outer rotor
3. Inner rotor
4. Thickness gauge
5. Straightedge
1. Retainer
2. Relief spring
3. Relief valve
1. Lower crank case
2. Oil pump
Side Clearance
Using straightedge and thickness gauge, measure side clearance.
Limit on side clearance: 0.11 mm (0.0043 in.)
ASSEMBLY
1) Wash, clean and then dry all disassembled parts.
2) Apply thin coat of engine oil to inner and outer rotors, and inside
3) Install outer rotor to pump case No.1.
4) Install relief valve, relief spring and retainer to oil pump case
5) Install oil pump case pins to oil pump case No.2.
4. Oil pump case No.2
5. Oil pump case pin
6) Assemble oil pump. After assembling oil pump, check to be sure
INSTALLATION
1) Install oil pump and baffle plate to lower crank case and tighten
surfaces of oil pump case.
No.2.
Tighten retainer to specified torque.
Tightening Torque
(a): 29 N·m (2.9 kg-m, 21.0 lb-ft)
that rotor turns smoothly by hand.
Tightening Torque
(a): 12 N·m (1.2 kg-m, 9.0 lb-ft)
bolts to specified torque.
NOTE:
When installing oil pump, be careful not to allow pins to fall
off.
Tightening Torque
(a): 20 N·m (2.0 kg-m, 14.5 lb-ft)