Suzuki Baleno Manual page 1536

6A1-76 ENGINE MECHANICAL (G13/G16 TYPE ENGINE)
8) Install pistons and connecting rods as previously outlined.
9) Install oil pump strainer and oil pan as previously outlined.
10) Install cylinder head assembly to cylinder block as previously
outlined.
NOTE:
Tighten cylinder head bolts to specified torque as pre-
viously outlined. Whenever installing cylinder head to
new cylinder block, use the following procedure to tighten
cylinder head bolts.
D Tighten cylinder head bolts to specified torque as pre-
viously outlined and loosen them once till tightening
torque becomes "zero". And then torque them to speci-
fication again.
11) Install camshaft, crankshaft timing belt pulley, timing belt,
crankshaft pulley, water pump pulley, etc., as previously out-
lined.
12) Install clutch to flywheel (for M/T vehicle). For clutch installa-
tion, refer to "CLUTCH" section.
13) Install engine mountings and brackets.
Tightening Torque
(a): 55 N·m (5.5 kg-m, 40.0 lb-ft)
(b): 45 N·m (4.5 kg-m, 32.5 lb-ft)
(c): 23 N·m (2.3 kg-m, 17.0 lb-ft)
14) Install engine assembly to vehicle as previously outlined.