Suzuki Baleno Manual page 1653

1. Water pump
1. Water pump 2. Gasket
1. Water pump 2. Rubber seal
1. Oil level gauge guide
2. Generator adjusting arm
1. Heater outlet pipe bolt
2. Thermostat cap
3. Exhaust manifold cover
INSPECTION
NOTE:
Do not disassemble water pump.
If any repair is required on pump, replace it as assembly.
Rotate water pump by hand to check for smooth operation.
If pump does not rotate smoothly or makes abnormal noise, re-
place it.
INSTALLATION
1) Install new pump gasket to cylinder block.
2) Install water pump to cylinder block.
Tightening Torque
(a): 11 N·m (1.1 kg-m, 8.0 lb-ft)
3) After installing water pump, install rubber seal between water
pump and oil pump.
4) Install belt tensioner, timing belt and timing belt outside cover
according to procedure described in item "TIMING BELT AND
TENSIONER" in Section 6A1.
5) Install generator adjusting arm.
6) With engine oil applied to O-ring, install oil level gauge guide.
7) Adjust drive belt tension. (Refer to Section 0B.)
8) Fill cooling system.
9) After installation, check each part for leakage.
3. Generator
FOR 1.8L ENGINE MODEL
REMOVAL
1) Disconnect negative cable at battery.
2) Drain coolant.
3) Remove radiator outlet hose from thermostat cap.
4) Remove heater outlet pipe bolt.
5) Remove generator belt referring to "GENERATOR BELT" in this
section.
ENGINE COOLING 6B-21