Suzuki Baleno Manual page 1746

6E1-82 ELECTRONIC FUEL INJECTION SYSTEM (G13/G16 ENGINE WITHOUT WU TWC)
1. Fuel delivery pipe
2. Fuel injector
3. Grommet
4. O-ring
5. Cushion
FUEL INJECTOR
ON-VEHICLE INSPECTION
1) Using sound scope or such, check operating sound of injector
when engine is running or cranking.
Cycle of operating sound should vary according to engine
speed.
If no sound or an unusual sound is heard, check injector circuit
(wire or coupler) or injector.
1. Sound scope
2. Injector
2) Disconnect coupler from injector, connect ohmmeter between
terminals of injector and check resistance.
Resistance of injector : 12 – 13 W at 20 C, 68 F
If resistance is out of specification, replace.
3) Connect coupler to injector securely.
1. Injector
REMOVAL
1) Relieve fuel pressure in fuel feed line. Refer to "FUEL PRES-
SURE RELIEF PROCEDURE" in Section 6.
2) Disconnect battery negative cable at battery.
3) Disconnect fuel injector couplers.
4) Remove fuel delivery pipe bolts.
5) Remove fuel injector(s).
CAUTION:
A small amount of fuel may come out after removal of
fuel injectors, cover them with shop cloth.
INSPECTION
WARNING:
As fuel is injected in this inspection, perform in a well
ventilated area and away from open flames.
Use special care to prevent sparking when connecting
and disconnecting test lead to and from battery.