Suzuki Baleno Manual page 1660

3) Install pipe cover to body. Be sure to use new nuts.
4) Connect fuel hoses to fuel pipes.
5) Connect brake pipe joints referring to SECTION 5.
6) With engine "OFF" and ignition switch "ON", check for fuel
leaks.
7) Bleed air in brake system referring to SECTION 5.
FUEL FILLER CAP
Remove cap, and check gasket for even filler neck imprint, and de-
terioration or any damage. If gasket is in malcondition, replace cap.
NOTE:
If cap requires replacement, only a cap with the same features
should be used. Failure to use correct cap can result in critical
malfunction of system.
1. Fuel filler cap
2. Gasket
FUEL FILTER
REMOVAL
1) Relieve fuel pressure in fuel feed line referring to SECTION 6.
2) Disconnect negative cable at battery.
3) Place fuel container under fuel filter.
4) Disconnect inlet and outlet hoses from fuel filter.
WARNING:
A small amount of fuel may be released after fuel hose
is disconnected. In order to reduce the chance of per-
sonal injury, cover hose and pipe to be disconnected
with a shop cloth. Be sure to put that cloth in an ap-
proved container when disconnection is completed.
5) Remove fuel filter.
6) Remove bracket from fuel filter.
1. Feed hose
2. Fuel filter
ENGINE FUEL 6C-5