1. Accelerator cable
2. Adjusting nut
3 Lock nut
1. Lever stopper
2. Throttle lever
3. Pedal stopper bolt
ELECTRONIC FUEL INJECTION SYSTEM (G13/G16 ENGINE WITHOUT WU TWC) 6E1-69
PRECAUTION
When hoses are disconnected and system components are re-
moved for service, reinstall components properly, and route and
connect hoses correctly after service. Refer to Emission Control In-
formation Label (if equipped) for proper connection of hoses.
ACCELERATOR CABLE
ADJUSTMENT
1) With throttle valve closed, check accelerator pedal play which
should be within the following specification.
Pedal play "a" : 2 – 7 mm (0.08 – 0.27 in.)
If measured value is out of specification, adjust it to specification
with cable adjusting nut.
2) With accelerator pedal depressed fully, check clearance be-
tween throttle lever and lever stopper (throttle body) which
should be within the following specification.
Clearance "b"
(With pedal
depressed fully)
If measured value is out of specification, adjust it to specification
by changing height of pedal stopper bolt.
: 0.5 – 2.0 mm (0.02 – 0.07 in.)