Suzuki Baleno Manual page 2182

THROTTLE POSITION SENSOR
(TP SENSOR)
INSPECTION
1) Disconnect negative cable at battery and disconnect throttle
2) Using an ohmmeter (2), check potentiometer resistance be-
3) Connect throttle position sensor (1) connector.
4) Connect negative cable to battery.
CRANKSHAFT POSITION SENSOR
INSPECTION
1) Disconnect negative cable at battery.
2) Disconnect engine position sensor coupler.
3) Using an ohmmeter, check sensor coil resistance between ter-
1. Crankshaft position sensor
2. VSS
3. Control cable bracket
4. Transmission
4) Connect crankshaft position sensor coupler.
5) Connect negative cable to battery.
ENGINE AND EMISSION CONTROL SYSTEM (XUD9BSD ENGINE) 6E3-13
position sensor (1) connector.
tween terminals under each condition given in table below.
If check result is not satisfactory, replace injection pump assem-
bly.
TP sensor potentiometer resistance
TERMINALS
Between "1" and
"3" terminals
Between "2" and
"3" terminals varying according to throttle valve opening
NOTE:
There should be more than 600 W resistance difference be-
tween when throttle valve is at idle position and when it is ful-
ly open.
minal "1" and terminal "2".
If check result is not satisfactory, replace crankshaft position
sensor.
Engine position sensor coil resistance: 315 – 405 W
RESISTANCE
1700 " 100 W
1200 " 60 W - 1800 " 90 W