Suzuki Baleno Manual page 1617

6A3-78 ENGINE MECHANICAL (J18 TYPE ENGINE)
1. Mounting member
2. Left mounting
3. Right mounting
4. Right mounting bracket
5. Engine front torque bush
INSTALLATION
1) Install clutch cover and clutch disk, referring to Section 7C1.
2) Connect transmission to engine, referring to Section 7A.
3) Lift engine with transmission into engine compartment, but do
4) Install engine right mounting to right mounting bracket and stiff-
5) Install engine left mounting to body.
6) Install mounting member to front member and suspension
7) Tighten bolts and nuts of all parts installed in above steps 4),
8) Remove lifting device.
9) Reverse removal procedures for installation of remainder.
6. Engine rear mounting
7. Suspension frame
8. To front member
9. To body
A. M / T vehicle
B. A / T vehicle
10) Adjust gear shift control cable, referring to Section 7A.
11) Refill transmission with gear oil, referring to Section 0B.
12) Refill engine with engine oil, referring to Section 0B.
13) Refill cooling system, referring to Section 6B.
14) Upon completion of installation, Check to make sure that there
15) Adjust accelerator cable play, referring to Section 6E2.
not remove lifting device.
ener.
frame.
5) and 6) to specified torque.
Tightening Torque
(a): 55 N·m (5.5 kg-m, 40.0 lb-ft)
(b): 19 N·m (1.9 kg-m, 13.5 lb-ft)
(c): 45 N·m (4.5 kg-m, 32.5 lb-ft)
D Push in each drive shaft joint fully so that snap ring engages
with differential gear or center bearing support.
Use care not to damage oil seal lip when inserting.
D Clamp electric wire securely.
is no fuel leakage, coolant leakage, transmission oil leakage
or exhaust gas leakage at each connection.